Cold Rolling Mill
Precision cold rolling mills for stainless steel, silicon steel and carbon steel strip, engineered for controlled reduction, accurate thickness regulation and stable strip shape. Energy consumption can be reduced by up to 30% relative to conventional configurations, with AGC/AFC-ready automation.
Five mill configurations, supported by a single material plan.
JINYE cold rolling mills reduce stainless steel, silicon steel and carbon steel strip while holding thickness and strip shape within specification. The configuration is selected from the material, gauge and target tolerance rather than the reverse. The range extends from the 20-high Sendzimir mill for thin, hard strip to the 4-high mill for general cold rolling and capacity upgrades.
The 20-high Sendzimir mill rolls precision and thin strip down to 0.03 mm final thickness. JINYE has also developed a domestic 20-high solution that rolls 201 stainless steel, widening the material and production range a plant can run on a single mill. Across the family, energy consumption can be reduced by up to 30% relative to conventional configurations, depending on the process and drive design.
Every mill is AGC/AFC-ready, maintaining gauge and flatness under automatic control. Final rolling force, roll system, motor power, coil weight and automation scope are confirmed during project engineering.
J— Jay, General Manager, JINYE
Select the mill configuration matched to your strip.
Five cold rolling mill configurations share one material plan, AGC/AFC-ready automation and in-house manufacturing, installation and commissioning.
20-high Sendzimir Cold Rolling Mill
350–1780 mm · 500–800 m/min · down to 0.03 mm
View →18-high Cold Rolling Mill
350–1780 mm · 500–800 m/min
View →Offset 8-high Cold Rolling Mill
350–1780 mm · 500–800 m/min
View →6-high Cold Rolling Mill
550–1780 mm · 600–1500 m/min
View →4-high Cold Rolling Mill
350–1450 mm · 200–500 m/min
View →From your strip data to a confirmed configuration
Process and material review
JINYE confirms material grade, incoming and target thickness, strip width, coil weight, line speed and process route.
Configuration match
The mill type is selected and the roll system, drive and AGC/AFC scope are defined to suit the strip and the downstream line.
Manufacturing, installation and commissioning
JINYE manufactures the mill, installs it on site, commissions it and provides ongoing technical support.
Final rolling force, roll system, motor power, coil weight and automation scope are confirmed during project engineering.
Cold rolling mill
Submit your strip data and production target. JINYE responds within one business day with a proposed configuration and the points confirmed at engineering review.
- Material grade, width, thickness range and coil weight
- Target gauge, tolerance and line speed
- Reply within one business day